Conrad Johnson MF – 2275

Planet Audio
Planet Audio

Differing primarily in power output rating, these amplifiers share a common circuit design. High voltage FETS permit highly linear operation of the critical first voltage gain stage, while bi-polar transistors are used to configure an output stage with low output impedance to deliver maximum current to reactive speaker loads.

Linear operation of the audio circuit requires a power supply designed to maintain absolutely fixed operating voltages while meeting current demands that fluctuate rapidly with the music itself. This imposes on the power supply similar design and component choice requirements as on the audio circuit itself. These amplifiers feature discrete dc regulators to power the critical voltage gain stage. The power supplies and grounds for the input and output stages are run by separate power transformer windings to isolate the input stage from the
effects of the substantial current flows required in the output stage.

Circuit design is a combination of science and art.

At every step consideration must be given to how a circuit will be implemented. The realized performance will depend critically on the selected component parts. Conrad-Johnson products are known for unmatched quality of parts with custom-made film capacitors and precision metal film and metal foil resistors. We even use large 30 micro-Farad polypropylene capacitors for critical circuit applications where other designs commonly use non-polar electrolytic capacitors, the factor of 1000 reduction in dielectric absorption of polypropylene resulting in a cleaner sound. The power supply electrolytic capacitors are bypassed with high quality polypropylene film capacitors that provide a small but quicker responding current reservoir.

For those wishing to take the musical experience a step further there are available special “SE” versions of these amplifiers which achieve further refinement in imaging, focus, and detail by upgrading a dozen or more critical capacitors to our proprietary CJD Teflon hybrid capacitors and a couple of dozen resistors to precision metal foil types.

Our obsession with parts quality extends to the connections within the circuit itself.

Power supply, signal and ground traces and wiring are parts of the circuit with limitations and shortcomings that must be accounted for. To enable the output stage to deliver substantial bursts of current, the layout provides storage capacitors close to each output device. The internal power supply connections and ground returns between the main supply and these local storage depots are accomplished with heavy, audiophile grade multi-stranded wire in order to minimize the impedance of these longer runs.

Thoughtful engineering, specification of high quality component parts, and painstaking care in production make these exceptional audio amplifiers. We invite you to arrange an audition with your conrad-johnson dealer to confirm for yourself their extraordinary musical performance.

MF2275

135 Watts per channel from 20 Hz to 20 KHz at no more than 1.0% THD or IMD, both channels driven into 8 ohms.

Sensitivity

MF2275 1.35 Volts rms to rated power

Frequency Response (at 10 Watts)

20 Hz to 20 kHz, +/- .1 dB

Hum and Noise

100 dB below rated power Input

Impedance

100 KOhms

Dimensions

MF2275 14.625D x 19W x 4.875H inches